Hi
I'm in the process of setting up a HyperV iSCSI boot environment which consists of the following components:
FI6248UP
5108/2208XP
FAS2240/ONTAP 8.1.3
B200M3/VIC1240/PortExpander
I was wondering if someone could shed some light on the actual Windows installation phase. I'm able to establish the initial iSCSI initialization successfully (using 1 path for now) as you can see from below:
However, I'm unable to view the LUN within the windows installation phase.I've uploaded the enic Cisco drivers under /Network/MLOM/enic6x64 as you can see for my VIC1240/PortExpander
Although I've installed the enic6x64, the next screen shown below suggests that Windows is still unable to view the NetApp LUN. Am I installing the wrong drivers for iSCSI boot or is there something fundamentally missing from this setup.
Kind Regards,
Osama Masfary
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Hi Osama,
I am familiar with that issue. Run into the same thing.
You have to remove your driver CD-ROM (e.g. iSO), re-insert the Windows Setup DVD. Then hit 'Refresh'. only then your disks will be recognized. If that ain't work either and you use NetApp, make sure you have configured a LUN ID on your iGroup settings. But I think the DVD and refresh will probably work.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Comments
0 comments
Please sign in to leave a comment.