Module available for "Show cellular 0/2/0" in IOS XE

Looking at using YDK for automation of cellular features for Polaris/XE based platforms, couldn't find the Yang module that modules the show cellular commands, like "show cellular hardware", is there some modules doing this or some oper modules that could be used the do own scripting.

R1#show cellular 0/2/0 hardware

Modem Firmware Version = SWI9X30C_02.20.03.00

Modem Firmware built = 2016/06/30 10:54:05

Hardware Version = 1.0

Device Model ID: EM7455

International Mobile Subscriber Identity (IMSI) = 123456700000141

International Mobile Equipment Identity (IMEI) = 356129070052474

Integrated Circuit Card ID (ICCID) = 8952530076180130141

Mobile Subscriber Integrated Services

Digital Network-Number (MSISDN) =

Modem Status = Modem Online

Current Modem Temperature = 35 deg C

PRI SKU ID = 1102526, PRI version = 002.017_000, Carrier = Generic

OEM PRI version = 002

This Native module can be used for configuration, but seems not for the show commands. Try this class .

While there is generic support for Cellular interfaces, Couldn't see any module/class that would give you cellular-specific configuration or operational data. When it comes to Cellular controllers, your Cisco-IOS-XE-controller module gives you some cell-specific bits that might help from a config standpoint. That said, could not find any cell-specific operational models.

Articles in this section

Comments