Upgrade from M81KR to VIC1280

Hello all,

I have (3) B230M2 blades with M81KR CNA.  In order to upgrade UCSM from 2.1.3 to 2.2.5 to add B200M4 blades into the environment, I am planning to replace the M81KR's with VIC1280's.  I'm looking for any advice.

The blades are going to stay in the same slots they are in currently.  I think I should be able to power them down, replace the hardware, re-ack the blade.  It should be that simple right?  Has anyone done this and have a "war-story" to share?

Thanks!

--Greg

I'll answer my own question in case anyone ever looks into this. 

This was a very simple operation.  Vacated the ESXI host and put into maintenance mode, shut down the host.  Pulled the blade, swapped the M81KR with the VIC1280 and rebooted.

The balde required a re-ack to properly identify the new adapter and it booted up without issue.